Fence Gates in Columbus, GA
Gates swing open and shut every day, so they wear out long before the panels around them. We put in new fence gates and fix old ones all over Columbus: narrow walk gates, two-leaf gates that clear a mower or trailer, and driveway gates on bigger properties.
If your gate drags, needs a lift to latch or swings open on its own, the fix is usually a post, a brace or new hardware rather than a whole new fence.
Free gates quote
Takes about 30 seconds. Prefer to talk? (706) 641-7040
Please add your name and a phone number we can reach you at, then send again.
Why Columbus gates sag
A sagging gate is almost always a hinge-post problem. Clay that stays soggy lets the post lean a little more each month under the weight of a wood gate, and loose sand lets it rock. The cure is a bigger concrete footing under the hinge post, a switch to steel, or a brace from the low hinge corner up to the high latch corner.
Size counts too. One wood leaf wider than about four feet pulls hard on its hinges. For a riding mower, a work trailer or a boat headed to Lake Harding, two leaves held with a cane bolt outlast one wide gate. If a wood gate has dropped before, a steel frame behind the pickets usually ends the problem.
Gate types
Walk gates
A 3- or 4-foot gate in the same style as your fence. Spring hinges that pull it shut are worth adding if you have pets or a pool.
Double drive gates
Two leaves with a cane bolt for openings from 8 to 12 feet.
Steel-frame wood gates
A welded frame behind pickets that match the fence, built for wide openings.
Driveway gates
Aluminum, steel or pipe gates for long driveways, ready for an opener later.
What affects gate pricing
- Opening width, and a single leaf versus a pair.
- Wood, steel-frame or all-metal construction.
- Hinges, latches, locks and any pool-rated hardware.
- Replacing or reinforcing the hinge post.
- Openers, keypads and the wiring to run them.
Fence Gates questions
Can a sagging gate be fixed without replacing it?
Most of the time. The fix might be a reset hinge post, a turnbuckle cable or brace, or a rebuilt frame. With a solid post to work from, the job is short and much cheaper than replacing the gate.
What gate width do I need for a trailer?
Most trucks and trailers need 10 to 12 feet, and a riding mower usually needs 5 or 6. Measure the widest thing that will pass through, leave a foot of margin, and go with a double gate for anything much wider than 5 feet.
More fence services
Fence Gates in Columbus: get your free quote
Describe the gate problem or the opening you need to fill, and a local crew will come out to look at it in Columbus or nearby.